ktm250sx Posted May 4, 2014 Share Posted May 4, 2014 Er det nok gods å gjenge i for denne gjengedimensjonen? Quote Link to comment Share on other sites More sharing options...
avtreksfeil Posted May 4, 2014 Share Posted May 4, 2014 Jepp.... Quote Link to comment Share on other sites More sharing options...
ktm250sx Posted May 4, 2014 Author Share Posted May 4, 2014 Takk for det! Quote Link to comment Share on other sites More sharing options...
Skee Posted May 5, 2014 Share Posted May 5, 2014 Her ser du hva A-Tec anbefaler som største gjengediameter for ei 19.5mm tykk pipe: http://www.a-tec.no/vedlikehold-av-a-tec-lyddempere Og det er nettopp M18x1. Quote Link to comment Share on other sites More sharing options...
ktm250sx Posted May 5, 2014 Author Share Posted May 5, 2014 Takk for svar! Da blir det M18x1. Quote Link to comment Share on other sites More sharing options...
Joika Posted May 5, 2014 Share Posted May 5, 2014 Tror nok jeg heller ville valgt M16/M15 pga brystning.Større flate å rette demperen mot. Quote Link to comment Share on other sites More sharing options...
Erlend Meyer Posted May 5, 2014 Share Posted May 5, 2014 1,5mm brystning er omtrent minimum av hva som anbefales. Man kan gå under det, har selv vært nede i 1mm uten problemer, men sjansene for krøll øker. Man må feks sjekke at ikke entringen på mutteren er faset mer enn absolutt nødvendig... Quote Link to comment Share on other sites More sharing options...
Mailman Posted May 12, 2014 Share Posted May 12, 2014 19mm er minimum for 18x1 gjenger,så du har ikke akkurat mye å gå på. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.