Jump to content

Mauser M67 cal. 22 ?


killakee

Recommended Posts

Hei igjen godt folk...

lurte på om Mauser M67 cal. 22 er en god rifle?

prøvd og søke på nett og finne ut noe men finner bare masse andre mauser rifler en den jeg leter etter :(

håper noen vet noe om denne eventuelt link til side som det står noe om den ....

håper den er bra for jeg har fått en SNASEN pris... (SIKLE)

 

takker for alle svar:)

MvH kjellemann

Link to comment
Share on other sites

fant dette på wikipedia angående denne:

mvh

tore

 

The Mauser M67 is a bolt-action rifle made by Kongsberg Våpenfabrikk (currently Kongsberg Small Arms) of Norway, based on actions from Mauser M98k left by German armed forces in 1945. The M67 replaced the M59 in 1967 and was phased out of production about 1988 with the closedown of Kongsberg Våpenfabrikk regular small-arms production.

Before the Sauer 200 STR was approved for Scandinavian target shooting, the M67 and the Krag-Jørgensen were the most popular taget rifles in Norway. Due to the Krag's propensity to change its point of impact under wet conditions, many shooters preferred to use the Krag for shooting on covered ranges and the M67 for field shooting.

Most parts of this rifle, like the M59, were made from former Mauser M98 rifles but fitted with a heavy target barrel, a new oversize target stock, Busk target front and rear peep sight, match trigger, and a soft rubber recoil pad.

Accuracy was about reasonable for a target rifle, the factory guaranteed 10 hits in a 7cm x 10cm circle at 100 m (328 ft).

The gun weighed 6,400 grams and was available in 7.62x51 (.308 Win), 6.5x55 Mauser/Skan and .22 LR for the recruit-class.

Although a common target rifle in Norway, in was criticized for its stock-bedding. The action was almost glued to the stock, and stock/action disassembly was almost impossible without destroying the stock.

Because of the use of old parts and heat treating, the Mauser extractor claw frequently broke.

In the .22LR version, the barrel was simply switched and the magazine floorplate and spring removed. Although the barrel was aligned with the bolt, no modifications was made to the firing pin, thereby penetrating the thin .22 case, affecting both consistency and accuracy. The fired casing had to be removed with a screwdriver.

The last models to leave the factory, in case of the 6.5 Mauser, was improperly chamber reamed, causing the case to stick in the chamber.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...